Kingston KVR16LN11/8 8GB DDR3L 1600MHz DIMM PC Bellek

Kingston | KVR16LN11/8 | 740617225914
683,88 TL
  • Ürün Özellikleri
  • Ödeme Seçenekleri
  • Yorumlar (0)
  • Tavsiye Et
  • Resimler
  • KVR16LN11/8
    8GB 2Rx8 1G x 64-Bit PC3L-12800
    CL11 240-Pin DIMM



    This document describes ValueRAM's 1G x 64-bit (8GB) DDR3L-1600 CL11 SDRAM (Synchronous DRAM), 2Rx8, low voltage, memory module, based on sixteen 512M x 8-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1600 timing of 11-11-11 at 1.35V or 1.5V. This 240-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows: 

    JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V) Power Supply
    VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V)
    800MHz fCK for 1600Mb/sec/pin
    8 independent internal bank
    Programmable CAS Latency: 11, 10, 9, 8, 7, 6
    Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
    8-bit pre-fetch
    Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
    Bi-directional Differential Data Strobe
    Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
    On Die Termination using ODT pin
    Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C
    Asynchronous Reset
    PCB: Height 0.740” (18.75mm) or 1.180” (30.00mm)

    CL(IDD):  11 cycles
    Row Cycle Time (tRCmin):  48.125ns (min.)
    Refresh to Active/Refresh Command Time (tRFCmin) :  260ns (min.)
    Row Active Time (tRASmin):  35ns (min.)
    Maximum Operating Power:  (1.35V) = TBD W*
    UL Rating:  94 V - 0
    Operating Temperature:  0o  C to 85o C
    Storage Temperature:  -55o C to +100o C

    Garanti Bilgisi
    Kingston Resmi Garantili
    Teslimat Bilgisi
    En Geç 2 İş Günü içerisinde Kargo
T-Soft E-Ticaret Sistemleriyle Hazırlanmıştır.