HyperX Fury 8GB HX316C10FR/8 DDR3 1600MHz PC Bellek

Kingston | HX316C10FR/8 | 740617230468
702,15 TL
  • Ürün Özellikleri
  • Ödeme Seçenekleri
  • Yorumlar (0)
  • Tavsiye Et
  • Resimler
  • Fury

    HX316C10FR/8

     

     

     

    HX316C10FR/8
    8GB 1G x 64-Bit DDR3-1600
    CL10 240-Pin DIMM


    DESCRIPTION
    HyperX HX316C10FR/8 is a 1G x 64-bit (8GB) DDR3-1600 CL10 SDRAM (Synchronous DRAM) 2Rx8 memory module, based on sixteen 512M x 8-bit DDR3 FBGA components. This module has been tested to run at DDR3-1600 at a low latency timing of 10-10-10 at 1.5V. Additional timing parameters are shown in the PnP Timing Parameters section below. The JEDEC standard electrical and mechanical specifications are as follows: 


    Note: The PnP feature offers a range of speed and timing options to support the widest variety of processors and chipsets. Your maximum speed will be determined by your BIOS.


    PnP JEDEC TIMING PARAMETERS:
    • DDR3-1600 CL10-10-10 @1.5V
    • DDR3-1333 CL9-9-9 @1.5V
    • DDR3-1066 CL7-7-7 @1.5V


    SPECIFICATIONS
    CL(IDD): 10 cycles
    Row Cycle Time (tRCmin): 48.125ns (min.)
    Refresh to Active/Refresh Command Time (tRFCmin): 260ns (min.)
    Row Active Time (tRASmin): 37.5ns (min.)
    Maximum Operating Power: TBD W*
    UL Rating:  94 V - 0
    Operating Temperature: 0C to 85 C
    Storage Temperature:  -55C to +100 C

    *Power will vary depending on the SDRAM used.


    FEATURES
    • JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
    • VDDQ = 1.5V (1.425V ~ 1.575V)
    • 800MHz fCK for 1600Mb/sec/pin
    • 8 independent internal bank
    • Programmable CAS Latency: 11, 10, 9, 8, 7, 6
    • Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
    • 8-bit pre-fetch
    • Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
    • Bi-directional Differential Data Strobe
    • Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
    • On Die Termination using ODT pin
    • Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C
    • Asynchronous Reset
    • Height 1.291” (32.80mm) w/heatsink, double sided component

     


     

     

     

    Garanti Bilgisi
    :
    Kingston Resmi Garantili
    Teslimat Bilgisi
    :
    En Geç 2 İş Günü içerisinde Kargo
T-Soft E-Ticaret Sistemleriyle Hazırlanmıştır.